Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
Is the state of protect card IS, STBYH?
13
Enter
14
where:
AID=Equipment Access Identifier of the DS3 card to be replaced.
Did output return COMPLD or DENY?
15
Release loopbacks on DS3 card to be replaced. Refer to Operation and Administration
16
manual (PN 3EM13851AF).
Release test connections on DS3 card to be replaced. Refer to Operation and
17
Administration manual (PN 3EM13851AF).
Enter
18
where:
AID=Equipment Access Identifier of the DS3 card to be replaced.
Did output return COMPLD or DENY?
19
Remove and replace DS3 card. Refer to DLP-101.
20
Enter
21
where:
AID=Equipment Access Identifier of the DS3 card just replaced.
Did output return COMPLD or DENY?
22
Enter
23
where:
AID=Equipment Access Identifier of the DS3 card just replaced.
Replace DS3 Card with a DS3 Card
If yes, go to step 14.
If no, go to step 31.
SW-TOPROTN-EQPT::AID;
If COMPLD, go to step 16.
If DENY, go to step 31.
for DS3 card being replaced.
RMV-EQPT::AID;
If COMPLD, go to step 20.
If DENY, go to step 31.
for replacement DS3 card.
RST-EQPT::AID;
If COMPLD, go to step 23.
If DENY, go to step 31.
to verify state of DS3 card.
RTRV-EQPT::AID;
to switch working DS3 card to protect.
DLP-130
5-45
Advertisement
Table of Contents
