Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
Set PM Mode
Enter
15
where:
x=Facility Type (EC1, GIGE, OC3, OC12, OC48, OC192, OFA, STS1, STS3C, STS12C,
STS48C, T1, T3, VT1).
AID=Access Identifier of the facility.
LOCN=Location:
PMSTATE=PM state: either
Go to step 1.
16
Retrieve PM Reporting Schedule
Enter
17
where:
x=ALL or Facility Type (EC1, GIGE, OC3, OC12, OC48, OC192, OFA, STS1, STS3C,
STS12C, STS48C, T1, T3, VT1).
AID is the access identifier of the facility.
Go to step 1.
18
Schedule PM Reporting
Enter
19
[MONLEV],,,[TMPER],[TMOFST];
or
SCHED-PMREPT-x::[AID]:::[REPTINVL],[REPTSTATM],[NUMREPT],[MONTYPE],
[MONLEV],,,[TMPER],[TMOFST];
where:
x=
ALL
STS3C, STS12C, STS48C, T1, T3, VT1).
AID=Access identifier of the facility.
REPTINVL=Reporting interval, indicating how often to generate reports:
, or
1-DAY
REPTSTATM=Next reporting time (hour:minute) starting on a 15-minute boundary,
specified in the format hh-mm.
NUMREPT=Number of reports to generate, or is omitted for continuous (unlimited)
reporting.
MONTYPE=Monitored type to report (&-grouping is supported), or is omitted for all
types.
MONLEV=Discrimination level of the requested monitored parameter, given in the
Performance Monitoring
SET-PMMODE-x::AID:::LOCN,ALL,[PMSTATE];
,
ALL
NEND
RTRV-PMSCHED-x::AID;
SCHED-PMREPT-ALL:::::[REPTINVL],[REPTSTATM],[NUMREPT],[MONTYPE],
or the Facility Type (EC1, GIGE, OC3, OC12, OC48, OC192, OFA, STS1,
, or is omitted to use the value specified for TMPER.
15-DAY
(near end), or
(far end).
FEND
(default) or
.
ON
OFF
RTL-101
,
15-MIN
3-7
Advertisement
Table of Contents
