Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
Set laptop or VDT terminal session to following settings:
51
–
–
–
–
Insert new CCC. Refer to DLP-101.
52
Close latch on OOS TC. Refer to
53
Watch the laptop or VDT as CCC goes through a startup sequence.
54
When prompted, press any key to stop the auto-boot.
55
At the LOADER> prompt, enter
56
Press
57
Enter
At the LOADER> prompt, enter
58
Is the date returned correct?
59
Repeat step
60
At the LOADER> prompt, enter
61
Press
62
Enter
Various messages display. On successful reboot, system responds with the following:
INITIALIZING SYSTEM MANAGER...
STARTUP COMPLETE.
PCM file load complete: CLI, TL1 and Snmpd enabled
NOTICE: This is a private computer system.
Unauthorized access may lead to prosecution.
Username:
Remove laptop or VDT and CCC interface cables connected to DIAG port on CCC.
63
Replace Common Control Card (CCC)
9600 Baud
1 Stop Bit
No Parity
No Flow Control
.
If yes, go to step
If no, enter correct date using
58
to verify system returns correct date.
to start reboot.
DLP-101
steps
54
through 60.
.
factory defaults
.
date
61
date MM/DD/YYYY
.
reboot
DLP-128
and press
.
Enter
5-33
Advertisement
Table of Contents
