Table of Contents
Advertisement
DLP-101
Is card being removed a CCC?
14
Loosen thumbscrews on flash-disk access cover of CCC being removed. Slide cover up
15
and remove.
Press flash-disk ejectors on each flash disk in CCC being removed. Ejector handle is
16
inside flash-disk slot above flash disk. See figure 101-4.
Physically remove disks that were deactivated in procedure and set them aside. Note
17
slot from which each disk was removed.
Is module a CCC, TC, or SSC?
18
Determine type of interlock switch/lever on module. Figure
19
Figure
Is lever type A or type B?
20
Push interlock switch to the right. See figure 101-5.
21
Go to step 24.
22
Disengage interlock lever and switch. See figure 101-6.
23
5-14
If yes, go to step 15.
If no, go to step 18.
Figure 101-4. Flash Disk Ejector
If yes, go to step 19.
If no, go to step 26.
101-6
shows type B lever.
If type A, go to step 21.
If type B, go to step 23.
FLASH DISK
FLASH-DISK
EJECTOR
677-0108-1
090804
Module Mechanical Removal and Replacement
3EM13853AF
Issue 01, September 2007
101-5
shows type A lever.
Advertisement
Table of Contents
