Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
IXL-101
Alarm and Event Condition Clearing Procedures
Refer to table
101-A
how to clear the condition type. The EQUIPMENT and FACILITY columns list the entities to which
a condition type can apply. Depending on the entities affected, some condition types have more than
one corresponding procedure.
In the EQUIPMENT column, entities are listed by software mnemonic. Refer to
corresponding hardware mnemonics. In the FACILITY column also, entities are listed by software
mnemonic. Observe the following definitions:
•
Stand-alone DS3: DS3 that is not embedded
•
Embedded DS3: DS3 embedded in EC1, OC-3, OC-12, OC-48, or OC-192
•
EC1: EC1
•
OC3: OC-3
•
OC12: OC-12
•
OC48: OC-48
•
OC192: OC-192
•
STS1: STS-1 embedded in EC1, OC-3, OC-12, OC-48, or OC-192
•
STS3c: STS-3c embedded in OC-3, OC-12, OC-48, or OC-192
•
STS12c: STS-12c embedded in OC-12, OC-48, or OC-192
•
STS48c: STS-48c embedded in OC-48 or OC-192
•
T0: T0 enbedded in T1 enbedded in DS3, T3, or VT1.5
•
T1: T1 enbedded in DS3, T3, or VT1.5
•
VT1.5: VT1.5 embedded in STS-1
The RTRV-ALM-ALL command is used to retrieve alarm condition types present in the system.
The RTRV-COND-ALL command is used to retrieve event (non-alarmed or not-reported) condition
types present in the system.
Alarm and Event Condition Clearing Procedures
to identify a condition type and the corresponding procedure, which describes
IXL-101
IXL-103
for
2-3
Advertisement
Table of Contents
