Table of Contents
Advertisement
DLP-135
Do any facilities on card to be removed have state of IS,WRK?
8
Enter
9
where:
OCn=Optical facility type (OC3, OC12, OC48, or OC192)
Are any ports on the card to be removed listed as ACTIVE in the output?
10
Enter
11
replaced.
where:
OCn=Optical facility type (OC3, OC12, OC48, or OC192)
AID=Access Identifier of facility on card to be removed.
Repeat step
12
Go to step 31.
13
BLSR Protection
Enter
14
where:
WEST=West port of the protection pair
Observe output.
15
Enter
16
where:
AID=Access Identifier of facility on card to be replaced
Observe output. Does CONDDESCR parameter indicate IDLE?
17
5-66
If yes, go to step 9.
If no, go to step 31.
RTRV-FFP-OCn;
If yes, go to step 11.
If no, go to step 31.
OPR-PROTNSW-OCn::AID:::MAN;
9
to switch all working traffic off card to be replaced.
RTRV-BLSR-TRC::WEST;
RTRV-COND-BLSR::AID;
If yes, go to step 18.
If no, go to step 39.
to switch all working traffic off the card to be
to check BLSR state.
3EM13853AF
Issue 01, September 2007
Replace OC-n Line Card
Advertisement
Table of Contents
