Table of Contents
Advertisement
DLP-137
Wait for the "A" disk to synchronize.
85
While disk is synchronizing, a BKUPMEMSYNCH condition is present. This condition
86
clears when process completes.
Enter
87
Standby CCC.
where:
AID=Access Identifier of the "B" disk in the standby CCC
Did output return COMPLD or DENY?
88
Wait for the "B" disk to synchronize.
89
While disk is synchronizing, a BKUPMEMSYNCH condition is present. This condition
90
clears when process completes.
Enter
91
Observe output. Note state of disks.
92
Are disks in both CCCs in a valid state (One Disk A is IS,WRK, one Disk A is
93
IS,STBYH, one Disk B is IS,WRK, and one Disk B is IS,STBYH)?
Contact next level of technical support for assistance.
94
95
STOP. This procedure is complete.
5-82
ACT-DISK::AID::::MODE=SEC,ACTION=ACTIVATE;
If COMPLD, go to step 89.
If DENY, go to step 94.
RTRV-DISK;
If yes, go to step 95.
If no, go to step 94.
3EM13853AF
Issue 01, September 2007
to activate disk "B" in the
Replace Timing Card (TC)
Advertisement
Table of Contents
