Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
DLP-126
Replace GIGE Card
PURPOSE
This procedure provides instructions to replace a GIGE card.
GENERAL
For information on TL1 command syntax, refer to the 1677 SONET Link Commands and Messages
manual (PN 3EM13852AF).
STEP
PROCEDURE
1
DANGER: Possibility of personal injury. Cards can be installed or removed with rack
power on. Hazardous electrical potentials are present; use extreme care when
installing or removing cards with power on.
WARNING: Possibility of equipment damage. This equipment contains static-
2
sensitive devices. Refer to
If GIGE card is carrying unprotected traffic, provision this traffic to another circuit.
3
Enter
4
where:
AID=Equipment Access Identifier of GIGE card.
Observe output.
5
Enter
6
where:
AID=Equipment Access Identifier of GIGE card to be replaced.
Did output return COMPLD or DENY?
7
Remove and replace GIGE card. Refer to DLP-101.
8
Enter
9
where:
AID=Equipment Access Identifier of GIGE card just replaced.
Replace GIGE Card
RTRV-EQPT::AID;
to remove GIGE card.
RMV-EQPT::AID;
If COMPLD, go to step 8.
If DENY, go to step 11.
RST-EQPT::AID;
Introduction
for special handling instructions.
DLP-126
5-23
Advertisement
Table of Contents
