Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
Go to step 27.
16
Locate three card-slot adapter marked RH.
17
Hold adapter with notch on the right and RH marking on top. See figure 138-3.
18
Insert tabs on card-slot adapter into metal backplane support so the adapter is over
19
slots 13, 14, and 15.
WARNING: Possibility of equipment damage. To prevent damage to captive
20
screw, never tighten it with a power screwdriver and never tighten it more
than .09 m-kg (8 in.-lbs).
Use a #2 × 8-inch Phillips screwdriver to tighten captive screw of card-slot adapter to
21
secure it in place.
Go to step 27.
22
Removing a Three or Two Card-slot Adapter for Full-high Card Support
Locate half-high slots to convert to full-high slots.
23
Use #2 Phillips screwdriver to loosen captive screw that secures card-slot adapter. See
24
figure 138-1.
Then remove adapter from chassis.
25
Store card-slot adapter in a convenient place for future use.
26
Is there another card-slot adapter be install or remove?
27
28
STOP. This procedure is complete.
Remove/Install Card-Slot Adapter
If yes, go to step 1.
If no, go to step 28.
DLP-138
5-85
Advertisement
Table of Contents
