Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
DLP-148
Replace DS0G (DS0G)
PURPOSE
This procedure provides instructions replace a DS0 Groomer (DS0G) module.
GENERAL
For information on TL1 command syntax, refer to the 1677 SONET Link Commands and Messages
manual (PN 3EM13852AF).
STEP
PROCEDURE
1
DANGER: Possibility of personal injury. Cards can be installed or removed with rack
power on. Hazardous electrical potentials are present; use extreme care when
installing or removing cards with power on.
WARNING: Possibility of equipment damage. This equipment contains static-
2
sensitive devices. Refer to
Enter
3
where:
AID=Access Identifier of DS0G to be replaced.
Observe output.
4
Determine AID of mate DS0G. Refer to table 148-A.
5
WORKING DS0G CARD SLOTS PROTECT DS0G CARD SLOTS WORKING/PROTECT PAIRS
3AB
14AB
Is mate DS0G present?
6
Enter
7
where:
AID=Access Identifier of mate DS0G.
Replace DS0G (DS0G)
to check state of DS0G to be replaced.
RTRV-EQPT::AID;
Table 148-A. Protect and Working DS0G Card Slots
4AB
15AB
If yes, go to step 7.
If no, go to step 20.
to check state of mate DS0G.
RTRV-EQPT::AID;
Introduction
for special handling instructions.
DLP-148
3AB/4AB
14AB/15AB
5-111
Advertisement
Table of Contents
