3EM13853AF
Issue 01, September 2007
TAP-107
SYNCSEC Alarm
PURPOSE
This procedure provides instruction to clear a SYNCSEC alarm against a TC.
GENERAL
SYNCSEC indicates secondary timing reference is not available and/or no backup TC module is
available.
This procedure assumes the user is logged into the alarmed Network Element (NE) using a telnet
session to port 3083.
For information on TL1 command syntax, refer to the 1677 SONET Link Commands and Messages
manual (PN 3EM13852AF).
STEP
PROCEDURE
Enter
1
Observe output. Note primary reference and secondary reference.
2
Enter
3
Observe output. Note any defects.
4
Contact next level of technical support for assistance.
5
6
STOP. This procedure is complete.
SYNCSEC Alarm
RTRV-SYNCN;
to verify timing source on indicated card.
RTRV-SYNCN-SRC;
TAP-107
4-37