Table of Contents
Advertisement
DLP-101
Is card just inserted a CCC?
42
If card is a CCC 104, verify part number and mnemonic on cover match the CLEI code
43
on card. Refer to the Product Information manual (PN 3EM13848AF).
Reinstall flash disk access cover on each card and tighten thumbscrews.
44
Remove protective caps from fiber cables and port adapters if applicable.
45
Always inspect and clean a fiber-optic cable and adapter before reconnecting. Refer to
46
DLP-100
Reconnect any cables or wires that were disconnected in step
47
card.
Is replacement card an OC-48 IOC?
48
Slide shield over cables and engage hooks on shield with slots on front panel of card.
49
See figure 101-3.
Ensure transmit cable and receive cable align with TX and RX labels, respectively, on
50
side of shield. (This allows identification of cables without removing shield.)
Align thumbscrews on shield with threaded hole on port adapter housing.
51
Use #2 Phillips screwdriver to tighten thumbscrews.
52
Is replacement module a CCC, TC, or SSC?
53
Is lever type A or type B (from step 34)?
54
Push interlock switch to the left.
55
Go to step 58.
56
Engage interlock switch and lever. See figure 101-9.
57
5-18
If yes, go to step 43.
If no, go to step 45.
for more information.
If yes, go to step 49.
If no, go to step 53.
If yes, go to step 54.
If no, go to step 58.
If type A, go to step 55.
If type B, go to step 57.
Issue 01, September 2007
10
Module Mechanical Removal and Replacement
3EM13853AF
to the replacement
Advertisement
Table of Contents
