Table of Contents
Advertisement
DLP-138
Select action.
2
Is there an OC-192 card in slot 6?
3
Is there an OC-192 card in slot 12?
4
Install a Two Card-slot Adapter for Half-high Card Support
Locate two empty full-high slots to convert to half-high slots.
5
Hold two-card-slot adapter so notch is on upper right side. See figure 138-1.
6
Insert tabs on card-slot adapter into metal backplane support.
7
WARNING: Possibility of equipment damage. To prevent damage to captive
8
screw, never tighten it with a power screwdriver and never tighten it more
than .09 m-kg (8 in.-lbs).
Tighten captive screw of card-slot adapter to secure it in place.
9
Go to step 27.
10
Install a Three Card-slot Adapter for Half-high Card Support
Locate three card-slot adapter marked LH.
11
Hold adapter with notch on the right and LH marking on top. See figure 138-2.
12
Insert tabs on card-slot adapter into metal backplane support so the adapter is over
13
slots 3, 4, and 5.
WARNING: Possibility of equipment damage. To prevent damage to captive
14
screw, never tighten it with a power screwdriver and never tighten it more
than .09 m-kg (8 in.-lbs).
Use #2 × 8-inch Phillips screwdriver to tighten captive screw of card-slot adapter to
15
secure it in place.
5-84
To convert any IOC slot except 5A, 5B, 13A, or 13B to a half-high slot,
go to step 5.
To convert slot 5A or 5B to a half-high slot, go to step 3.
To convert slot 13A or 13B to a half-high slot, go to step 4.
If yes, go to step 11.
If no, go to step 5.
If yes, go to step 17.
If no, go to step 5.
3EM13853AF
Issue 01, September 2007
Remove/Install Card-Slot Adapter
Advertisement
Table of Contents
