Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
Figure 129-2. Remove Cable to Rack-Mounted Connector Panel
Unplug cable from back of connector panel.
15
Disconnect cables from transmit and receive ports on front of panel. Carefully mark
16
each cable for easy reinstallation.
Untie cables from cable-tie brackets.
17
Select action.
18
Pull unattached edge of adapter plate away from equipment rack.
19
Use a #2 Phillips screwdriver to remove screws that attach cable-tie brackets to
20
connector panel being replaced.
Use a #2 Phillips screwdriver to loosen thumbscrews that attach connector panel to
21
adapter plate, then place connector panel to one side.
Replace DS3 Connector Panel
To remove a connector panel on left edge of adapter plate, only remove
screws that attach adapter plate to left edge of equipment rack. Then go
to step 19.
To remove a connector panel on right edge of adapter plate, only remove
screws that attach adapter plate to right edge of equipment rack.
DLP-129
677-0110-1
090804
5-41
Advertisement
Table of Contents
