Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
Enter
76
Observe output. Note states of disks in CCC just replaced.
77
Is state of disks in CCC just replaced OOS-MA?
78
Activate the "A" disk as secondary in CCC that has been replaced.
79
Enter
where: AID=Access Identifier of the "A" disk in CCC just replaced (DISK-{A9, A10}).
Did output return COMPLD or DENY?
80
Enter
81
Observe output. Note states of disks in CCC just replaced.
82
Verify PST=OOS-AUMA and SST=SWDL. While secondary disk synchronizes, a
83
BKUPMEMSYNCH condition exists. Wait until BKUPMEMSYNCH condition clears
before continuing. Note that MAN condition clears.
Wait for disk to synchronize.
84
Activate the "B" disk as secondary in CCC that has been replaced.
85
Enter
where: AID=Access Identifier of the "B" disk in CCC just replaced (DISK-{B9, B10}).
Did output return COMPLD or DENY?
86
Enter
87
Observe output. Note states of disks in CCC just replaced.
88
Verify PST=OOS-AUMA and SST=SWDL. While secondary disk synchronizes, a
89
BKUPMEMSYNCH condition exists. Wait until BKUPMEMSYNCH condition clears
before continuing. Note that MAN condition clears.
Replace Common Control Card (CCC)
to check state of disks.
RTRV-DISK;
If yes, go to step 79.
If no, go to step 109.
ACT-DISK::AID::::MODE=SEC,ACTION=ACTIVATE;
If COMPLD, go to step 81.
If DENY, go to step 109.
RTRV-DISK;
ACT-DISK::AID::::MODE=SEC,ACTION=ACTIVATE;
If COMPLD, go to step 87.
If DENY, go to step 109.
RTRV-DISK;
DLP-128
5-35
Advertisement
Table of Contents
