Table of Contents
Advertisement
DLP-147
STEP
PROCEDURE
1
DANGER: Possibility of personal injury. Cards can be installed or removed with rack
power on. Hazardous electrical potentials are present; use extreme care when
installing or removing cards with power on.
WARNING: Possibility of equipment damage. This equipment contains static-
2
sensitive devices. Refer to
3
CAUTION: Possibility of service interruption. This procedure should be performed during
a maintenance window. Cross-connections and facilities will need to be deleted on working
slot DS3 cards before the ECC module can be entered into service.
Preparation for Removal of the DS3 Card
Enter
4
where:
AID=Equipment Access Identifier of DS3 card to be replaced.
Observe output.
5
Is DS3 card to be replaced a protect module (located in slots IOC-1-A, IOC-1-B,
6
IOC-17-A, or IOC-17-B)?
Is the protect module an ECC?
7
DS3 and ECC modules can be in the same protection group only if the protection
8
module is an ECC.
Replace protection module (DS3) with an ECC module also?
Is state of protect module IS, WRK?
9
5-106
for DS3 card being replaced.
RTRV-EQPT::AID;
If yes, go to step 9.
If no, go to step 7.
If yes, go to step 12.
If no, go to step 8.
If yes, go to step
module first.
If no, go to step 42.
If yes, go to step 42.
If no, go to step 10.
Introduction
for special handling instructions.
1
and follow procedure to replace protect card with ECC
Issue 01, September 2007
Replace DS3 Card with an ECC Card
3EM13853AF
Advertisement
Table of Contents
