Table of Contents
Advertisement
Main Menu
Hub Replacement
NOTE:
Use only genuine Honda wheel weights for aluminum wheels. Non-genuine wheel weights may corrode and damage
the aluminum wheels.
Remove the center cap by prying it out with a flat screwdriver. Use a rag at the point you are going to pry, because
aluminum alloy wheels can be easily damaged. Avoid damage to the cap by not allowing it to fall during removal.
Before installing the brake disc, clean the mating surface of the rear hub and inside of the brake disc.
Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.
FLANGE BOLT
10 x 1.25 mm
65 N
.
m (6.5 kg-m,
47 Ib-ft)
HUB BEARING
ASSEMBLY
Inspect for faulty
movement and wear.
Replacement, page
18-33
BRAKE DISC
Check for wear or
rust.
Inspection,
Section
REAR HUB UNIT
Check for damage or
cracks.
Replacement, page 18-33.
Corrosion resistant bolt/nut
Table of Contents
KNUCKLE
19.
FLAT HEAD SCREW
6 x 1.0 mm
10 N
.
m (1.0 kg-m,
7 Ib-ft)
SPLASH GUARD
WHEEL NUT
12 x 1.5 mm
110 N
.
m (11 kg-m,
80 Ib-ft)
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
