Hopper Assembly - Canon imageRUNNER 2270 Service Manual

4) Lift the front of the laser unit [1], and
slide it to the front.
F-7-40
When sliding out the laser scanner unit, be
sure to take care not to touch the PCB
mounted to the laser scanner unit. (The
PCB is equipped with a laser scanner
intensity adjustment variable resistor, and
contact with the PCB can change the
adjustment setting.)
7.12.3.11 Removing the

Hopper Assembly

1) Remove the inside base cover [1] and
the inside right color [2].
2) Disconnect the 3 connectors [1] found at
the front and the connector [2] found at
the rear.
0007-8360
3) Open the 11 wire saddles [1], and pull
out the harness [3] through the hole [2]
in the plate.
Chapter 7
F-7-41
F-7-42
7-37