Error Codes - Canon imageRUNNER 2270 Service Manual

Chapter 15
Cause
The symbol \ is used in the search condition.
The combination of characters used in the search
condition fails to make up a correct search condition.
There must be as many "s as there are "s
The symbol * is not included within parentheses.
If LDAP of the server and the character code is version
2 (JIS), there is a character that is not part of the ASCII
code (0x20-0x7E).
The version setting of the server is wrong, and the search cannot be initiated. Check the settings.
In user mode, the LDAP server settings (server LDAP
version and character code) is set for version 3;
however, the LDAP server is operating for version 2.

15.3.2 Error Codes

Cause
# 001
There is a paper or original jam.
# 003
A communication lasting longer than a specific period
of time (64 min) will cause an error state.
# 005
The target does not respond within 35 sec.
The target is a non-G3 model.
# 009
There is no paper.
The cassette is not fitted properly.
15-36
Remedy
Remove the symbol \ from the search condition, and
try once again.
Check to be sure that the combination of characters is
in keeping with the rule; then, try once again.
Remove any character that cannot be used; then, try
once gain.
In user mode, set the LDAP server settings so that the
LDAP server version and the character code are both
version 2.
T-15-8
Remedy
Remove the jammed paper or original.
1. Decrease the resolution for transmission.
2. In the case of reception, ask the source to decrease
the resolution or divide the original.
Check to be sure that the target is ready to
communicate; then, try once again.
Check the target.
Supply paper.
Fit the cassette correctly.
0008-0315