Canon imageRUNNER 2270 Service Manual page 889

4.3.7.7 Removing the
Pickup Unit 4
Refer to procedure 4.3.2
4.3.7.8 Removing the
Sensor Base
1)Remove the 2 TP screws [1] and the
binding screw [2] at the rear of the
pickup assembly; then, detach the
bracket [3].
F-4-32
2)Disconnect the connector [1], and
remove the screw [2]; then, detach the
cassette pickup solenoid [3].
3) Remove the bushing [4] and the 5
screws [5]; then, detach the sensor base [6].
0003-3303
0003-3194
F-4-33
4.3.7.9
Take care not to orient the pickup unit
facing down when mounting the sensor
base; otherwise, the gears will fall out.
1) After fitting the bushing [1] to the frame,
mount the gear shaft [2].
F-4-34
Mounting
Sensor Base
Chapter 4
the
0003-3215
4-17