11) Connect the power cable to the wall outlet, and turn on the main power switch. See that
the machine is in a standby state, and start service mode.
12)
Make
the
(COPIER>FUNCTION>INSTALL>CARD); then, enter the appropriate card number (1
to 2001).
-Use the number that is the lowest of all the numbers that the user will be using.
-As many as 1000 cards may be used starting with the number entered.
13) Turn off the control panel power switch.
14) Turn off and then on the main power switch.
2.6.4 Installation in a NetSpot Accountant (NSA)
Environment
1) Make the following selections in user mode: system control setup>group ID
control>count control; then, see that the following numbers are available: ID00000001
to
ID00001000.
COPIER>FUNCTION>INSTALL>CARD.)
2) Make the following selections in user mode: system setup>network setup>TCP/IP
setup>IP address. Set the following: 'IP address', 'gateway address', 'subnet mask'.
following
selections
(If
you
F-2-74
in
the
entered
'1'
Chapter 2
machine's
service
0007-2764
in
service
mode
mode:
2-37