Canon imageRUNNER 2270 Service Manual page 757

Chapter 16
Sub-item
SL-ON Starting solenoid operation
<Operating procedure>
Operation specifications shall differ depending on the model.
1) Press SL to reverse its display. Then press the OK key to start
solenoid operation.
2) Press the OK key again to stop the operation.
(The operation stops automatically in five seconds but the status
changes to STOP only when the OK key is pressed again.)
MTR-ON Starting motor operation
<Operating procedure>
Operation specifications shall differ depending on the model.
1) Press MTR-ON to reverse its display. Then press the OK key to
start motor operation.
2) Press the OK key again to stop the operation.
(The operation stops automatically in five seconds but the status
changes to STOP only when the OK key is pressed again.)
ROLL- Cleaning the ADF roller
CLN
While the roller is being rotated automatically by a motor, press
alcohol-moistened lens cleaning paper against the roller for
cleaning.
<Operating procedure>
1) Press ROLL-CLN to reverse its display.
2) While the roller is rotating, press alcohol-moistened lens
cleaning paper against the roller for cleaning.
3) Press ROLL-CLN to reverse its display. Press the OK key to
stop the roller.
FEED-ON Checking ADF paper feed operation
<Operating procedure>
1) Press FEED-ON and then the OK key to start paper feed in the
operation mode set by FEED-CHK.
16-72
FEEDER >FUNCTION
Description Level
1
1
1
1