Canon imageRUNNER 2270 Service Manual page 730

Sub-item
BLANK-B Entering an adjustment value for the chipping width at the rear of an image
<Setting range> -128 to 127 (Default: 0)
Setting a greater value increases the chipping width.
If RAM on the DC controller circuit board has been cleared or the board itself
has been replaced, enter the value from the service label.
<HV-PRI>
Sub-item
OFST1-DC Entering an adjustment value for primary charge DC offset 1
<Setting range> -128 to 127 (Default: 0)
If RAM on the DC controller circuit board has been cleared or the board itself has
been replaced, enter the value from the service label.
Note: If the compound power circuit board has been replaced, enter the value from
the label affixed to the casing of the new compound power circuit board.
OFST1-AC Entering an adjustment value for primary charge AC offset 1
<Setting range> -128 to 127 (Default: 0)
If RAM on the DC controller circuit board has been cleared or the board itself has
been replaced, enter the value from the service label.
Note: If the compound power circuit board has been replaced, enter the value from
the label affixed to the casing of the new compound power circuit board.
COPIER > ADJUST > BLANK
Description
T-16-23
COPIER > ADJUST > HV-PRI
Description
Chapter 16
Level
1
Level
1
1
16-45