Canon imageRUNNER 2270 Service Manual page 638

Chapter 15
YY
*11 13, 25
*12 10, 12, 14,
22, 23, 24
- HD-CLEAR
When you have executed HD-CLEAR, all contents of the partition in question (files, sub
directories) will be lost.
The actual formatting will take place when the machine is started up after it has been turned
off upon execution of HD-CLEAN.
At this time, the Startup screen shows a progress bar, its edge reaching the end in about 5
min. Be sure not to turn off the power while the progress bar is moving.
This function (i.e., mode item) cannot be used for BOOTDEV and DOSDEV4; to re-format
any of these 2 partitions, you will have to use the SST.
15-32
Description
The ongoing write operation has
been suspended.
There is a system error or a packet
data error.
Remedy
There is a likelihood of the presence of damage to
the file data on the HDD (e.g., Box).
1. Set '0' for TYPE-TYPE, and execute HDD-
CHECK (40 to 50 min). Thereafter, turn off and
then back on the power.
2. If the symptom still exits after the foregoing,
set '1' for TYPE-TYPE, and execute HDD-
CLEAR.
(In the case of DOSDEV4 or BOOTDEV,
execute formatting and re-installation once
again.)
3. If the symptom still exists after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.
The data may be corrupted or there is a software
bug.
1. Start up in safe mode, and execute full
formatting using the SST and re-install the system
software (System, Language, RUI). Thereafter,
turn off and then back on the main power.
2. If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.