Canon imageRUNNER 2270 Service Manual page 547

Chapter 13
9) Hold down the control panel power
switch for 3 sec or more.
10) Go through the instructions on the
control panel for shut-down sequence so
that the main power switch may be turned
off.
11) Turn off the main power switch. Wait
for 3 sec or more, and turn it back on.
Unless you have registered 'system
control group ID' and 'system control ID
No.', you will not be able to register cards
for the device in the course of Net Spot
Accountant setup work.
12) Download the card ID.
Keep the machine in a standby state <
and download the card ID to be used from
the NSA>
13) Check the count control particulars in
user mode.
control
system
control>count control
See that only the downloaded ID data is
shown.
14) Check to see that the operation is
normal.
Make copies using a user card that has
been registered using the NSA, and check
to see that the count of the card in question
has been incremented correctly.
13-16
setup>group ID
13.5.4
Replacing
Main Controller
PCB
If you are replacing the main controller
PCB, be sure to transfer the following
components from the old to new PCB:
[1] boot ROM
[2] HDD
[3] image memory (SDRAM)
[4] counter memory PCB
F-13-24
If the user uses NetSpot Accountant
(NSA) in Combination with a Card
Reader
The SDRAM of the main controller retains
card ID used by NSA. If you have replaced
the main controller, you will have to
download the card data from NSA once
again to permit NSA to perform statistical
After
the
0007-9204