Canon imageRUNNER 2270 Service Manual page 643

Cause
# 011
The original to be transmitted is not placed properly.
# 012
The target is out of recording paper, and transmission
has failed.
# 018
There is no response to a redial attempt.
The target is engaged for a different communication,
and transmission has failed.
The settings do not match the settings of the target, and
the transmission has failed.
# 022
The particulars of the group address selected as the
forwarding target may have been deleted, or there is no
more than a user box, thus causing the transmission to
fail.
The attempt to transmit to an address registered in the
address book has failed because the address has been
removed from the address table while in wait for
transmission.
# 037
There is a shortage of memory, not permitting
reception.
# 080
F code is not set on the target.
# 081
The appropriate password is not set on the target.
# 099
The transmission has been suspended in the middle.
# 102
Remedy
Start over from the beginning.
Ask the target to supply recording paper.
Check to make sure that the target is ready for
communication; then, try once again.
Check to make sure that the target is ready for
communication; then, try once again.
Check to make sure that the target is ready for
communication; then, try once again.
Try transmitting once again.
Try once again.
Remove error files and unnecessary files to increase
available memory.
Check the F code of the target, and start over.
Check the password of the target, and start over.
Start over.
Chapter 15
15-37