Connecting The Cable - Canon imageRUNNER 2270 Service Manual

- When it wobbles in the direction shown
by the arrow B, tighten the screw at the
left side in the above picture.
A]
F-2-38
3) Mount the cassettes 1 and 2.
2.2.5 Connecting the
Cable
1) If you are installing a cassette pedestal,
remove the lattice connector cover, and
fit the lattice connector [1] of the
cassette pedestal to the machine.
[B]
[B]
0007-5059
[1]
[A
2) Connect the power plug to the power
outlet.
1. Power supply voltage shall be +/-10% of
the rating.
2. The amperage of the power supply must
be as rated.
3. Before connecting the power plug,
check to be sure that the main power
switch is off.
3) Turn on the main power switch.
- The machine issues a message to indicate
that it is loading programs.
- The machine issues a message to indicate
that its printer is getting ready for a job.
Turning Off the Main Power
Whenever you have to turn off the main
power, be sure to go through the following
to avoid damage to the hard disk:
1. Hold down the control panel power
Chapter 2
F-2-39
2-17