Canon imageRUNNER 2270 Service Manual page 621

Code Cause
0002 When the main power is turned on,
the communication IC (IPC) on the
DC controller PCB cannot be
initialized.
E711 There is an error in the IPC communication.
0001 The occurrence of an error has been
recorded in the error register of the
IPC chip 4 times or more within 1.5
sec.
0002 The occurrence of an error has been
recorded in the error register of the
IPC chip 4 times or more within 2
sec.
E713 There is an error in the communication with the finisher.
0000 The communication with the finisher
does not resume within 5 sec after it
has been disrupted.
E716 There is an error in the communication with the pedestal.
0000 After the presence of a pedestal has
been detected, the communication
fails to be normal for 5 sec.
E717 There is an error in the communication with the NE controller.
0001 The NE controller is not connected at
power on, although it was connected
before the power was turned off
because of an error.
0002 An IPC error has occurred while the
NE controller is in operation.
There is an open circuit for the IPC.
An error has occurred, and the IPC
communication remains disabled.
E719 There is a coin vendor error.
Remedy
Check the cable.
Check the cable.
Check the cable.
Check the cable. Replace the DC
controller PCB. Replace the finisher
controller PCB.
Check the cable. Replace the DC
controller PCB. Replace the pedestal
drive PCB.
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR>ERR.
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR>ERR.
Chapter 15
15-15