Canon imageRUNNER 2270 Service Manual page 734

Sub-item
MF-A6R Entering the basic paper width of the manual feed tray (A6R)
<Setting range> 0 to 1024 (Default: 175)
If RAM on the DC controller circuit board has been cleared or the board itself has
been replaced, enter the value from the service label.
For replacing the paper with detection VR or registering a new value for the firs
time, this service mode shall be executed by FUNCTION>CST.
MF-A4 Entering the basic paper width of the manual feed tray (A4)
<Setting range> 0 to 1024 (Default: 791)
If RAM on the DC controller circuit board has been cleared or the board itself has
been replaced, enter the value from the service label.
For replacing the paper with detection VR or registering a new value for the firs
time, this service mode shall be executed by FUNCTION>CST.
<FIXING>
Sub-item
FX-FL-SP Entering a fine adjustment value for the fixing film speed when plain paper is
used.
Make a fine adjustment of the target control speed for the fixing film speed when
plain paper is used.
<Setting range> -3 to 3 (Default: 0) (Unit: ms)
If RAM on the DC controller circuit board has been cleared or the board itself
has been replaced, enter the value from the service label.
FX-FL-TH Entering a fine adjustment value for the fixing film speed when thick paper is
used.
Make a fine adjustment of the target control speed for the fixing film speed when
thick paper is used.
<Setting range> -3 to 3 (Default: 0) (Unit: ms)
If RAM on the DC controller circuit board has been cleared or the board itself
has been replaced, enter the value from the service label.
COPIER > ADJUST > CST-ADJ
Description
T-16-27
COPIER > ADJUST > FIXING
Description
Chapter 16
Level
1
1
Level
2
2
16-49