Canon imageRUNNER 2270 Service Manual page 644

Chapter 15
Cause
There is a mismatch of F code or password.
# 107
There is a shortage of memory, not permitting
transmission.
# 701
The group ID set when the job was introduced no
longer exits. Or, the password has been changed.
# 702
The memory is full, not permitting transmission.
# 703
The memory image area is full, not permitting further
writing.
# 704
An error has occurred while an attempt is made to
obtain address information from the address book.
# 705
The image data size is in excess of the upper limit
imposed on transmission data size set in user mode,
thus causing suspension of transmission.
# 706
15-38
Remedy
Check the F code and the password of the target, and
start over.
1. Decrease the resolution, and try once again.
2. Remove unnecessary files to increase available
space.
Type in the correct group ID or the ID No. (using the
keypad); then, start over.
1. Wait a while. Try again until the ongoing
transmission of a job ends.
2. Try not to transmit to too many addresses at once;
rather, try dividing the address into smaller groups.
1. Wait a while. Try transmitting after the ongoing
transmission of a job ends.
2. Remove files from the Box; if the operation still fails
to return to normal, turn off and then back on the main
power.
Check the settings of the address, and try once again; if
the operation is still not normal, try turning off and then
back on the main power.
Try changing the upper limit imposed on transmission
data size as part of the communication control settings
of system control settings (user mode). When selecting
low resolution mode or using i-fax, try decreasing the
number of images to send at one time so that the
transmission will not be in excess of the upper limit
imposed on transfer data size.