Canon imageRUNNER 2270 Service Manual page 735

Chapter 16
Sub-item
FX-FL-LW Entering a fine adjustment value for the fixing film speed when low-speed plain
paper is used.
Make a fine adjustment of the target control speed for the fixing film speed when
low-speed plain paper is used.
<Setting range> -3 to 3 (Default: 0) (Unit: ms)
If RAM on the DC controller circuit board has been cleared or the board itself
has been replaced, enter the value from the service label.
<MISC>
Sub-item
IMG-DLY Entering a fine adjustment value for the image delay in the subscan direction
Make a fine adjustment of the image delay in the subscan direction when image data
is transferred from the controller board to the DCON board.
<Setting range> -128 to 127
iR2270/2270F/2870/2870F: +23 (Default)
iR3570/3570F/4570/4570F: +35 (Default)
If RAM on the DC controller circuit board has been cleared or the board itself has
been replaced, enter the value from the service label.
C1/2/3/4- Entering a horizontal registration adjustment value for Cassette 1/2/3/4
ADJ-Y Enter a laser write start position for paper fed from Cassette 1/2/3/4 according to the
registered numeric value.
<Setting range> -128 to 127 (Default: 0)
MF-ADJ-Y Entering a horizontal registration adjustment value for the multiple manual feed
tray
Enter a laser write start position for paper fed from the multiple manual feed tray
according to the registered numeric value.
<Setting range> -128 to 127 (Default: 0)
16-50
COPIER > ADJUST > FIXING
Description
T-16-28
COPIER > ADJUST > MISC
Description
Level
2
Level
1
2
2