Transfer Charging Roller - Canon imageRUNNER 2270 Service Manual

Chapter 7
9) Remove the 2 screws [1]; then, remove
the 2 bearings [2] and the sleeve holder
(rear) [3].
F-7-68
10) Remove the grip ring [1] and the screw
[2]; then, remove the washer [3],
bearings [4] [5], and sleeve holder
(front) [6].
F-7-69
7-46
11) Remove the developing cylinder [1].
F-7-70
When detaching/attaching the developing
cylinder from/to the developing unit, be
sure of the following:
1. A good number of self-taping screws are
used inside the developing unit. Be sure
not to tighten these screws too tightly
and damage the screw holes.
2. When removing
cylinder, be sure to remove the blade
unit first.
3. When attaching the developing cylinder,
be sure to fit it first to the developing
unit.
4. Do not touch the developing cylinder or
subject it to impact.
7.12.7
Transfer
Roller
7.12.7.1 Removing the
Transfer Roller
1) Open the right door [1].
the developing
Charging
0007-8431