Canon imageRUNNER 2270 Service Manual page 637

YY
*8 02
*9 03
*10 11,21
Description
A file system error has occurred.
There is poor contact of the HDD,
or a v.x Works system error has
occurred.
The HDD has poor contact.
Remedy
The system software is designed so that a
recovery session will not run for the boot partition
unless you use safe mode in combination with the
SST.
1. Start up in safe mode, and execute full
formatting using the SST and re-install the system
software (System, Language, RUI). Thereafter,
turn off and then on the main power.
2. If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.
1. Check the cable and power supply connectors.
2. If the symptom still exits after the foregoing,
start up in safe mode, and execute full formatting
using the SST and re-install the system software
(System, Language, RUI). Thereafter, turn off
and then back on the main power.
3. If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.
This type of error is highly rare in relation to read/
write operations.
1. Check the cable and the power supply
connectors.
2.If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and install the system software.
Chapter 15
15-31