Timing Of Increasing The Count - Canon imageRUNNER 2270 Service Manual

5461/ 5469/ 5462
** by default, not indicated; may be changed in service mode.
*** '1' is set for the following service mode item: COPIER>OPTION>USE>CNT-SW.
**** '1' is set for the following service mode item: COPIER>OPTION>USER>CNT-SW.

10.2.2 Timing of Increasing the Count

The timing at which the count is increased differs depending on the printing mode (single-
sided or double-sided), target of delivery, and type of accessory:
1. Singe-Sided Printing, 2nd Side of a Double-Sided Print
In single-side printing or for the 2nd side of a double-sided print, the count is increased
when the trailing edge of the sheet is discharged outside the machine in relation to the
output of the following sensors:
Condition
Finisher absent
Finisher present
2. 1st Side of a Double-Sided Print
When the double-sided print feed sensor (PS17) goes on, the machine will assume that
printing on the 1st side has been completed, thereby increasing the count.
T-10-2
Target of delivery
Tray 1
Tray 2
Tray 3
Sensor
Delivery sensor (PS14)
No. 2 delivery sensor (PS1A)
No. 3 delivery sensor (PS5)
Delivery sensor of the finisher
Chapter 10
0006-5385
10-5