Canon imageRUNNER 2270 Service Manual page 625

Code Cause
0001 The version of the language file on
the HDD and that of the bootable do
not match.
0002 The size of the language file on the
HDD is too large.
0003 There is no language file on the HDD
indicated by config.txt for a
switchover.
0004 An attempt to switchover to a
language on the HDD fails.
1000 The boot ROM that is mounted is of
the wrong type.
2000 The engine ID indicated by the
software ID is illegal.
E745 There is a fault on the TokeRing board.
0001 An attempt at PCI initialization has
failed.
0002 The MAC address is faulty.
0003 There is an error in the acquisition/
setting of board information.
0004 There is a connection error.
0005 Other Errors
E746 The accessories board is of the wrong type.
0003 At startup, a board for a different
model has been detected.
E748 There is a mismatch between controller board and SDRAM size.
Remedy
Download a language file of the correct
version.
Download a language file of the correct
version.
Download a language file of the correct
version.
Download a language file of the correct
version.
Replace the boot ROM with one of the
model in question.
Replace it with a software ID of the
correct model.
1. Disconnect and then connect the
TokeRing board.
2. Replace the TokeRing board.
1. Replace the TokenRing board.
1. Replace the TokenRing board.
1. Check the connection of the cable.
2. Replace the cable.
3. Check the power source of the MAU.
4. Replace the MAU.
5. Replace the TokenRing board.
Replace the UFR board of the correct
type (model).
Chapter 15
15-19