Canon imageRUNNER 2270 Service Manual page 919

Chapter 1
[3]
[1]
F-1-3
2) Connect the power cable to the wall
outlet.
3) Turn on the main power switch.
4) Start service mode a follows:
Press the User Mode key, press the 2 and 8
keys at the same time, and then press the
User mode key once again.
5) Set '1' to the following menu flag:
COPIER>OPTION>ACC>IN-TRAY.
COPIER>OPTION>ACC>IN-TRAY
When '1' is set to this mode item, tray B
will be enabled under 'special tray setup' in
user mode.
1-4
6) Hold down the control panel power
switch for 3 sec or more.
[2]
7) Go through the instructions indicated on
the control panel screen so that the main
power switch will be ready to be tuned
off.
8) Turn off the main power switch.
9) Wait for 3 sec or more; then, turn the
main power switch back on.
10) Start user mode.
11) Make the following selections:
common setup>special tray setup menu;
then, check to see that the copy tray (tray
B) menu has been added.
12) Select tray B for copying; then, make
test copies.
13) Change the tray settings to suit the
needs of the user.