Function Test <(6) Function Test - Canon ImageRUNNER 1022iF Service Manual

Left/right arrow key
<
>
15.15.5 FUNCTION TEST <(6) FUNCTION TEST>
/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
Function test ((6) FUNCTION TEST)
Press the numeric keypad key 6 on the test mode menu to select the function test.
Press numeric keypad keys 1 and 3 to 9 during the function test to enter the menus listed below.
Keypad
1
2
3
4
5
6
7
8
9
G3 signal transmission test (6-1: G3 480 bps Tx)
Press numeric keypad key 1 on the FUNCTION TEST menu to select the G3 signal transmission test. This test transmits 4800-bps G3 signals from the telephone
line connection terminal and speaker.
Sensor test (6-3: SENSOR)
This mode is used to verify the status of the unit sensors from LCD indications. Press numeric keypad key 3 on the FUNCTION TEST menu to select the sensor
test. LCD indications change as the associated sensors turn on and off.
Transmission speed
4800bps
7200bps
9600bps
12000bps
14400bps
16800bps
19200bps
21600bps
24000bps
26400bps
28800bps
31200bps
33600bps
T-15-24
Item Explanation
G3 signal transmission test Transmits 4800-bps G3 signals to a telephone line and
speaker.
Not used
Sensor test Sensor actuation test
ADF test ADF operation test
Book test Host machine operation test
Speaker test Speaker operation test
Operation panel test LCD, LED and control key operation test
Lamp test Contact sensor illumination test
Line signal reception test NCU board signal sensor and frequency counter operation test
Chapter 15
0013-1426
15-37