Programming Dme Control Module − Gt2 And Version X51 - Porsche 996 TT Repair Manual

911 Turbo (996).
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch ignition on.
2. Select vehicle type using the cursor keys. In the 911 Turbo − 911 (996).
3. Using the '| key, move from the vehicle type to the list of control units.
4. Select DME with the cursor keys and press the >> key.
5. Select "Control unit programming" with the cursor keys and press the >> key.
6. Select "Control unit programming with the cursor keys and press the >> key. Follow the
displayed programming instructions from the Porsche System Tester.
7. Enter the Veh. Ident. No. with the cursor keys, continue with >> and confirm with F7.
8. Enter the old DME (IPAS, vehicle − OLD) programming code with the cursor keys, continue with the
>> key and, after checking the code, confirm with F7.
9. Enter the new DME (IPAS, vehicle − NEW) programming code with the cursor keys, continue with the
>> key and, after checking, confirm with F7.
10. Enter the old immobilizer code (IPAS, vehicle − OLD), continue with the >> key, check the code again
and confirm with F7.
11. Enter the new immobilizer code (IPAS, vehicle − NEW), continue with the >> key, check the code
again and confirm with F7.
12. Select the required program map and confirm with the >> key. => Version (data records) 911 Turbo
(996)
13. The data status is loaded on to the DME control module. Do not interrupt the programming sequence.
14. When the programming period has expired, follow the instructions from the Porsche System
Tester − CAN TIME OUT −.
15. Press the >> key. For the learning and adaptation routine of the throttle (E−gas), switch the
ignition on for 1 minute without starting the engine and without actuating the accelerator pedal.
Then switch the ignition off for at least 10 seconds. This completes the adaptation of the throttle
adjusting unit and the programming sequence is complete.
16. Read out the fault memory and delete the fault − CAN TIME OUT − on every control unit that is
connected to the CAN.
top of page
Programming DME control module − GT2 and version X51
Note
• X51 − increased performance.
If the DME control module from a different GT2 vehicle is being used, proceed as follows. As a
•
check, the DME code and the immobilizer code of the vehicle in which the control module is being
installed (NEW) and of the vehicle from which the control module has been removed (OLD) are
required.
You can get the necessary codes from IPAS or from your importer by specifying the vehicle
•
identification number.
Programming the DME control module 911 Turbo (996)
einordnung
1210