Removing And Installing Selector Lever Cover Frame - Porsche 928 Workshop Manual

928 Automatic Transmission/Controls, Case
37
REMOVING AND INSTALLING SELECTOR LEVER COVER FRAME
Removing
1. Remove selector lever grip and take off
rubber boot.
2. Move selector lever to position "2" and
push rear locking bar forward against stop
with a suitable tool (e. g. scribe).
3. Move selector lever to position "R",
disconnect gate and push forward as far as
possible.
4. Push front locking bar forward against stop
with a suitable tool (e. g. scribe).
5. Move selector lever to position "P" and
press out cover frame carefully with a
suitable screwdriver applied at the left rear
corner.
6. Move selector lever to position "N" and
remove frame inclined toward rear.
Installing
1. Move selector lever to position "3".
2. Push gate in frame forward all the way,
3. Install cover frame in correct position and
move selector lever to position "P".
4. Push cover frame forward and move right
side to correct installed position (this is
done by lifting left rear corner slightly
and pushing down on right side).
5. Push down on left rear corner until frame
fits in center console correctly.
Printed in Germane - VIII, 1984 Removing and Installing Selector Lever
37-101
Cover Frame