A4/A5 Local Synthesize Module Replacement; Tools Required; Removal Procedure - Keysight E5052B Service Manual

Replacement Procedure

A4/A5 Local Synthesize Module Replacement

A4/A5 Local Synthesize Module Replacement

Tools Required

• TORX screwdriver, T10, T15, and T20
• Flat edge screwdriver
• Open-end torque wrench, 5/16 inch (set to 1.02 N-m / 9.0 lb-in) (for reconnecting SMA
connector)

Removal Procedure

Refer to Figure 6-20
Step 1. Remove the outer cover as described in
Step 2. Remove the front panel as described in
Step 3. Disconnect the semi-rigid cables (item 1).
Step 4. Remove each two TORX T10 screws (item 2) from the local synthesize module.
Step 5. Slide out the local synthesize module (item 3).
Step 6. Release the clamped cables from the clamp (item 4).
Step 7. Disconnect the RF cable (item 5) from the local synthesize module.
174
for this procedure.
"Outer Cover Removal" on page
"Front Panel Removal" on page
136.
138.
Chapter 6