Assigning Ip Addresses To Logo And Setting The Master Mode; Software Installation (Download) - Siemens SIMATIC HMI KTP400 Manual

4 Installation and Commissioning
4.1.3

Assigning IP addresses to LOGO and setting the master mode

Table 4-3
No. Action/response
Go to the "Network" item via the LOGO!
1.
display using the arrow keys C1▲ or C2▼ of
the LOGO! 8 and press OK.
Select the "IP address" item.
2.
3. Press the OK button of the LOGO! controller
and use the arrow keys C1▲, C2▼, C3 ◄ and
C4 ► to enter your LOGO!'s IP address (here:
192.168.1.13). Confirm with the OK button.
4. Press the ESC key to return to the previous
menu item and select "Set M/S mode".
5. For configuring the master LOGO!, select
"Master".
6. The configuration of the IP address and the
mode for the LOGO! is now complete. Press
ESC to return to the main menu
4.2

Software installation (download)

Note It is assumed that the required software LOGO!Soft Comfort V8 and WinCC
have been installed on your PC. No previous experience with the software is
required.
House Control and Weather Sensors - LOGO! Set 11
Entry ID: 68585346, V2.1, 09/2018
LOGO! Display
15