Sorting Events (Upper Panel); Choosing Format (Lower Panel); Time Of Day Including Time Difference Cpu/Local; Updating The Diagnostic Buffer - Siemens SIMATIC 6ES7673-2CC40-0YA0 Hardware Installation And Operating Manual

Operating the Controller - CPU 41x-2 PCI
•
A brief description
Additional information, depending on the event, such as the address of the
instruction that caused the diagnostic event and the mode transition that was
caused by the event
•
The event state (incoming or outgoing)
If a single parameter of text cannot be identified, the diagnostic buffer displays
the string "###". If no text exists for new modules or new events, the event
numbers and the single parameters are displayed as hexadecimal values.
If you have chosen Hexadecimal format, the hexadecimal values of the
selected event appear in the lower panel.
4.6.1

Sorting Events (upper panel)

You can sort the events listed in the upper panel by clicking the specific column:
•
Number (determined by time and date)
•
Event description
4.6.2

Choosing Format (lower panel)

You can display the diagnostic information in the lower panel in text or
hexadecimal (Hex) format. In Hex format, the hexadecimal values of the 20 bytes
of the selected event are displayed. To select the format:
•
Click Text to display the event details in text format.
•
Click Hex to display the hexadecimal values of the event.
4.6.3

Time of Day including Time Difference CPU/Local

If the check box is not active, the entries in the diagnostic buffer are stamped with
the time of day on the module, for example, the CPU. You use this setting if this
time is the same as the time at the location of the diagnostic buffer reader (the
same time zone).
If the check box is active, the correction value set for the time-of-day display is
applied. You use this setting if the location of the diagnostic buffer reader is in a
different time zone than the module. The check box can only be activated for
modules which support time-of-day status.
If you change the settings, the time entries in the diagnostic buffer are updated
immediately.
4.6.4

Updating the Diagnostic Buffer

To display the most up-to-date information in the window, select the "Update"
button.
68
Hardware Installation and Operating Manual, Edition 02/2006, A5E00273194-02
Windows Automation Center, WinAC Slot Version 4.0