Manual Grooving/Parting; Groove Cycle - Single - Siemens SINUMERIK 808D Programming And Operating Manual

Manual machining
3.4 Manual machining using cycles (functions)
See also
Principle operating sequence (Page 38)
General parameters (Page 41)
3.4.5

Manual grooving/parting

Functionality
The "Manual grooving" function is suitable for producing grooves on the peripheral surface
and face end and for tapping turned parts. Groove cycles can be used to produce filleted
corners or beveled edges on surfaces.
In addition, the "Multiple execution" function can be used to produce multiple tappings and
multiple grooves with a uniform offset.
Note
The grooving tool must be configured in the tool list; in doing so, the width of the tool must be
programmed via the parameter Panel width or via Cutting edge 1 (D1), Cutting edge 2 (D2).
3.4.5.1

Groove cycle - single

Operating sequences
You can access the grooving cycle overview by pressing the softkey "Groove" in the basic
screen for "Manual Machine Plus".
Figure 3-24
48
Grooving cycle overview - "Grooving cycle" selected
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
Manual Machine Plus (Turning)