Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Figure 299: Installing the power cable clamp
Ê Press down on the power cable clamp until it snaps into place.
Ê Remove the protective plastic cover from the CPU socket of the new system
board.
Ê Remove the CPU from the defective system board, see section
the CPU" on page
Ê Confirm that the CPU model number printed on the top of the CPU fits with
the requirements.
Ê Install the CPU on the new system board, see section
on page 324.
Ê Fit the protective plastic cover onto the socket of the defective system board
which will be sent back to spares.
I
Returned system boards without this cover probably have to be
scrapped.
"Installing the CPU heat sink" on page 330
Ê

14.7.1.4 Concluding steps

Ê Connect all cables to the system board.
I
For the cable plan, see chapter
Ê Reinstall all remaining system board components as shown in the related
sections:
TX1330 M4
322.
Upgrade and Maintenance Manual
System board and components
"Installing the CPU"
"Appendix B" on page
"Removing
477.
423