Concluding Steps; Removing 3.5-Inch Hdd Modules; Preliminary Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) / solid state drives (SSD)
7.3.7.4

Concluding steps

Ê If applicable, "Reassembling" on page
I
Please refer to your controller manual to configure the installed HDD.
7.3.8

Removing 3.5-inch HDD modules

Customer Replaceable Unit
(CRU)
Tools: tool-less
7.3.8.1

Preliminary steps

Ê If the HDD module to be removed is combined into a RAID array, proceed
as follows:
RAID level Procedure
RAID 0
Removing an HDD from a RAID 1 or RAID 5 array will not
result in data loss.
However, the removed drive needs to be replaced
immediately by an HDD module of the same or larger
RAID 1
capacity.
RAID 5
178
V
CAUTION!
RAID 0 provides no data redundancy.
In case of an HDD/SSD module is defect, all data
are lost!
I
After replacing the HDD module, RAID rebuild will
be performed as a background process, see
section "Performing a RAID array rebuild" on
page 117.
Upgrade and Maintenance Manual
67.
Hardware:
5 minutes
TX1330 M4