Connecting Cables; Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) / solid state drives (SSD)

7.3.10.6 Connecting cables

Figure 111: Connecting cables to the SAS backplane (example 4. 3.5-inch HDDs)
Ê Connect the cables to the backplane:
1 If applicable, riser card power cable
2 If applicable, OOB cable
3 SAS cable
4 Power cable
I
For the cable plan, see chapter

7.3.10.7 Concluding steps

Ê Insert all HDD/SSD modules, see section
on page 176.
I
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
"Installing the SAS expander board" on page 251
Ê
"Installing a system fan" on page 266
Ê
"Reassembling" on page 67
Ê
"Connecting the power cord" on page 78
Ê
"Switching on the server" on page 80
Ê
192
"Appendix B" on page
Upgrade and Maintenance Manual
477.
"Installing 3.5-inch HDD modules"
TX1330 M4