Concluding Steps; Replacing Accessible Drives; Preliminary Steps; Removing The Defective Accessible Drive - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

12.3.4 Concluding steps

"Reassembling" on page 67
Ê
"Connecting the power cord" on page 78
Ê
"Switching on the server" on page 80
Ê
12.4

Replacing accessible drives

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for installing mounting brackets)

12.4.1 Preliminary steps

"Locating the defective server" on page 51
Ê
"Removing backup and optical disk media" on page 99
Ê
"Verifying and configuring the backup software solution" on page 100
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
I
Removing the front cover is not required in order to replace an
accessible drive. The front cover only needs to be removed in order
to remove/install accessible drive dummy covers and this is not
necessary here.

12.4.2 Removing the defective accessible drive

Ê Remove all cables from the accessible drive.
Ê Remove the accessible drive, see section
on page 348.
TX1330 M4
Upgrade and Maintenance Manual
Accessible drives
Hardware: 15 minutes
"Removing an accessible drive"
349