Figure 309: Securing the accessible drive cage (B)
Ê Carefully turn the server upside down.
I
At least two people are needed to turn over a fully equipped server.
Remove HDDs and hot-plug PSUs in order to facilitate the task.
Ê Secure the accessible drive cage with the two screws (see circles) to the
bottom side of the server.
I
Note the correct screw positions: The screw hole on the right that has
been used in the floorstand model configuration remains empty.
Ê Reinstall the front panel (rotated by 90 degrees), see section
front panel module" on page
Ê Reinstall all accessible drives into their original bays (rotated by 90
degrees), see section
Ê Reinstall all accessible drive filler covers and front covers, see section
"Installing accessible drive dummy covers" on page
Ê If applicable, install an HDD extension box, see section
boxes" on page
Preparing the intrusion switch
Ê Remove the intrusion switch module, see section
switch cable" on page
I
It is not necessary to disconnect the intrusion switch cable from the
system board.
TX1330 M4
Converting a floorstand model to a rack model
380.
"Installing an accessible drive" on page
228.
441.
Upgrade and Maintenance Manual
"Installing the
344.
236.
"HDD extension
"Removing the intrusion
437