Removing The Tpm; Preliminary Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Ê Set the TPM Support and TPM State settings to Enabled.
Ê Under Pending TPM operation, select the desired TPM operation
mode.
Ê Save your changes and exit the BIOS.
I
For more information on how to access the BIOS and modify settings,
refer to the corresponding BIOS Setup Utility reference manual.

14.3.2 Removing the TPM

Field Replaceable Unit
(FRU)
Tools: Removing the system board:
– Phillips PH2 / (+) No. 2 screw driver
Removing the TPM:
– Bit screw driver
– flat nose pliers
– TPM bit insert
( )
* For Japan:
– TPM module fixing tool (S26361-F3552-L909)
V
CAUTION!
Advise your contact persons that they must provide you with all recovery
keys which belong to the system to restore them in the TPM later.

14.3.2.1 Preliminary steps

I
Preliminary steps are not necessary, if a system board has to be replaced
and the TPM is used again.
Ê Before removing the TPM, it is necessary to remove BitLocker-protection
from the computer and to decrypt the volume.
Ask the system administrator to turn off BitLocker-protection using the
BitLocker setup wizard available either from the Control Panel or Windows
Explorer:
TX1330 M4
( )
*
Upgrade and Maintenance Manual
System board and components
Hardware: 30 minutes
391