Replacing The Heat Sink; Preliminary Steps; Removing The Defective Heat Sink; Installing The New Heat Sink - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Processor (CPU)
11.3

Replacing the heat sink

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

11.3.1 Preliminary steps

Ê If applicable, "Locating the defective server" on page 51
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
Ê Remove the system fan module, see section
module" on page 81

11.3.2 Removing the defective heat sink

Ê Remove the CPU heat sink, see section
page 321.
Ê Remove the residual thermal paste from the CPU surface.
Ê Clean the CPU surface using a lint-free cloth.

11.3.3 Installing the new heat sink

Ê Remove the protective cover on the underside of the new heat sink.
V
CAUTION!
Do not touch the thermal paste on the underside of the heat sink.
Ê Install the CPU heat sink, see section
page 330.
332 Upgrade and Maintenance Manual
Hardware: 15 minutes
"Removing the system fan
"Removing the heat sink" on
"Installing the CPU heat sink" on
TX1330 M4